Standard_Parts_Catalogue

Page 994 | 3.1 Indexing, Locking, Blocking with Pins and Ball-Shaped Elements 1 d 1 2 Type How to order (Stainless steel) 1 2 GN616.1-M8-SN 1 d 1 2 Type How to order (Steel) 1 2 GN616.1-M10-S 2 Type S Steel, with standard spring load SS Steel, with high spring load SN Stainless steel, with standard spring load Spring plungers GN 616.1 are used for locking as well as for pressure and hold-off functions. Entry of liquids and dirt is prevented by the seal. The slit on the plunger side is used for screwing into pocket holes. For this, a special screwdriver is available as GN 611.5 (see table). see also... • Spring Plungers GN 616 (Bolt, without Seal) → Page 993 Information Specification • Type S / SS - - Housing steel, blackened - - Bolt steel, hardened • Type SN - - Housing stainless steel AISI 303 - - Bolt stainless steel AISI 303 • Pressure spring Stainless steel AISI 303 • Seal Rubber NBR (Perbunan ® ) • Identification of type SS: Housing with 2 longitudinal markings • Stainless Steel Characteristics → Page 2166 • RoHS • Screw Drivers GN 611.5 (Code no. see table) Accessory 1 d 1 d 2 Length l w Compression Spring load in N ≈ Standard (Type S / SN) Spring load in N ≈ High (Type SS) Code no. Screw driver Initial End Initial End M  8 3,8 26 3    9 24 17  39 GN 611.5-M10 M 10 4   28 3,5 15 30 22  43 GN 611.5-M10 M 12 6   35 4   24 50 40  80 GN 611.5-M12 M 16 7,5 40 5   36 58 44 113 GN 611.5-M16 GN 616.1 Spring Plungers Steel / Stainless Steel with Sealed Bolt