Standard_Parts_Catalogue

Page 714 | 2.4 Tensioning with Clamping Mechanisms Toggle clamps „Longlife“ GN 910.1 are an advance development of GN 810.1: The steel sheet design of the clamp and lever arms is replaced by precision or die-forged components. The remaining steel sheet metal parts have been reinforced, bearing pins and rivets are toughened and ground. These toggle clamps are therefore suitable for applications in which subs- tantial forces occur and in which a long service life is required. Extensive tests have shown that trouble-free function (under load) is en- sured also after one million clamping cycles. Stepped side washers are included. see also... • General Information for Toggle Clamps → Page 698 • Toggle Clamps GN 810.1 → Page 702 Information GN 910.1 Toggle Clamps Operating Lever Vertical, with Vertical Mounting Base, Heavy Duty Type „Longlife“ 1 Size 2 Type How to order 1 2 GN910.1-440-F 2 Type B Clamping arm with slotted hole (only size 220 and 440) F Clamping arm with bushing • Toggle clamp steel - - Precision casting - - Blackened • Lever arm steel - - Forged - - Blackened • Parts in sheet metal - Case-hardened steel - Blackened • Bearing pins and rivets Steel, hardened and ground • All moving parts Lubricated with special grease • Solid designed plastic handle Red, oil resistant • RoHS Specification * This size is fitted with a round handle at the lever arm and available only in type F. • Clamping Screws → Page 810 ff. Accessory Size h 3 h 4 ≈ l 1 l 2 l 3 m 1 m 2 m 3 r 1 r 2 s Type B Type F  220 16 27  91    86   51 46 20  8    8  77 72 6  440 24 45 129,5 129,5 66 66 30 10   12 107 107 10  850 * 30 - - 161   - 72 55 10   10 - 133 12 1540 * 35 - - 203   - 92,5 65 17,5 12,5 - 167 16 1 Size F H in N Holding capacity a b 1 b 2 b 3 b 4 d 1 d 2 d 3 h 1 h 2  220 2200 32 36 13  6  6 M  6 6,5 6,5 152  45,5  440 4400 34 54 20 10 10 M 10 8,5 10,5 235  69,5  850 *  8500 - 75 24 - 12 M 12 10,5 12,5 301  88   1540 * 15400 - 90 32 - 16 M 16 12,5 16,5 344 106