Standard_Parts_Catalogue

Page 411 | 1.4 Adjusting, Positioning, Locking with and without Position Indication Electrical and mechanical characteristics Supply voltage 24 V DC Power consumption 50 mA Frequency range 2.4 GHz ... 2.48 GHz Antenna connector SMA bushing Coaxial cable RG 174/U Protection class II Reverse voltage protection Yes Working temperature 0 °C ... 50 °C Humidity max. 80 % (without condensation) EMV acc. to EN 61000-6-2; EN 61000-6-3 Mounting on top hat rails acc. to IEC 60715 Integration maschine control with network cable RJ45 The position indicators and control communicate using a proprietary ELESA protocol. The control unit can only process the target and current position value of the position indicators and send these to the machine control. The machine control therefore cannot be accessed directly over the wireless network of the control unit. The radio communication is therefore protected against system alterations or third-party access. Disruptions or interference from other typical wireless networks, such as WiFi, Bluetooth, etc. do not impair the functio- ning of the system, but they may lengthen the response time of the position indicators to the control unit. Avoid placing the control unit immediately next to high-powered components, such as motors, converters, etc. If this is not possible, a safe distance of at least 200 mm should be ensured. Other important information and instructions can be found in the operating instruction for control units GN 9150. This is included with every control unit and can be downloaded from www.ganternorm.com in the ‚Service‘ section. Security information GN 9150 Control Units continued