Standard_Parts_Catalogue

Page 2116 | Load Rating Information Extensive test series were carried out in order to obtain strength details of the plastic cabinet U-handles listed below. The results provide informa- tion on the impact strength and the tensile strength under normal stress loads in two stress load directions. The impact strength S 1 and S 2 was determined using the outline drawing shown opposite: A cylindrical steel element rounded at the tip (weight 0.680 kg) repeatedly hits the handle, with the height of drop increased by 0.1 mm with every drop. Failure occurs at the specified S values. The details given on strength are non-binding guide values without any liability. In general, they do not constitute a warranty of quality. The user must determine from case to case if a product is suitable for the envisa- ged use. Strength Properties of Cabinet U-Handles in Plastic Sorted by Ascending Standard Numbers Arch Handles GN 365 → Page 168 Size  132 S 1 in J   15 S 2 in J    7 K 1 in N 2100 K 2 in N 2600 Cabinet U-Handles GN 525 → Page 119 Size   86  117  179 S 1 in J    5    6    7 S 2 in J    6   10    8 K 1 in N 2500 4000 3000 K 2 in N 2500 5000 2000 Cabinet U-Handles GN 528-PA → Page 120 Size   94  117  122  132  140  160  179  235 S 1 in J   15   20   25   27   27   29   20   40 S 2 in J    8   13   14   14   20   20   20   34 K 1 in N 3500 4500 3700 3500 3400 3300 2800 3200 K 2 in N 2500 2500 2500 2500 2600 2700 2700 3500 Impact strength S 1 = P x h 1 Impact strength S 2 = P x h 2 Breaking load K 1 Breaking load K 2 Ledge Handles GN 130 → Page 218 Size 100-M6 100-B4,5 S 1 in J    –   – S 2 in J    –   – K 1 in N 3000 700 K 2 in N 1900 900 Ledge Handles GN 130.2 → Page 219 Size 100-M4 100-B4,5 S 1 in J    –    – S 2 in J    –    – K 1 in N 3500 3000 K 2 in N 2800 2800 Finger Handles GN 224.3 → Page 171 Size  9 10 S 1 in J    6   10 S 2 in J - - K 1 in N - - K 2 in N 2300 2300