Standard_Parts_Catalogue

Page 1965 | 3.8 Adjusting, Moving with Guides, Spindles and Ball Rollers 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 1 d 1 2 Type 3 Identification no. How to oder 1 2 3 GN163.15-G50-A-4 GN 163.15 Base Plate Linear Actuator Connectors Stainless Steel 1 d 1 Bore with sleeve bearing b d 2 d 3 d 4 Mounting screws on the drive key k Clamping length l 1 m t x 1 x 2 y 1 y 2 z Screw location Accessory Recom. hand lever GN 911.3 for z l 2 G 30 22 6,5 37 M 4 50 36 35 6,5 60 42 60 42 M  8 63 78 G 50 30 10,7 60 M 6 85 48,5 60 9 105 74 105 74 M 10 78 92 Flanged linear actuator connectors GN 163.15 are based on flanged connector clamps. The additionally provided mounting holes are used to connect to the drive key of a linear actuator. Bores with the designation “ G ” are equipped with sleeve bearings. With the screw location z , the play of the guide bores d 1 can be adjus- ted or the linear actuator connectors can be clamped after adjustment. Type B is equipped with seals at the screw locations. For quick clamping without tools, the cap nut can be replaced by the adjustable hand levers GN 911.3 listed in the table as accessories. see also... • Linear Actuators GN 291 → Page 1950 • Linear Actuators GN 292 → Page 1952 • Linear Actuators GN 293 → Page 1953 Information • Stainless steel AISI CF-8 Matte shot-blasted • Sleeve bearing Plastic (PTFE) • Carriage bolt DIN 603 Stainless steel • Cap nuts DIN 917 / Washers Stainless steel • Seals - - Sealing disks Plastic (Polyacetal POM) - - Spacer ring Silicon, 40 ... 60 Shore A • Plastic Characteristics → Page 2158 • Stainless Steel Characteristics → Page 2166 • RoHS Specification 2 Type A Without seals B With seals 3 Identification no. 4 With stainless steel cap nut DIN 917 • Adjustable Hand Levers GN 911.3 → Page 1785 Accessory