Standard_Parts_Catalogue

Page 1956 | 3.8 Adjusting, Moving with Guides, Spindles and Ball Rollers 2 Type A Without seals B With seals 3 Identification no. 4 With 2 stainless steel cap nuts DIN 917 Two-way linear actuator connectors GN 132.15 / GN 132.25 are based on two-way connector clamps. The additionally provided mounting holes are used to connect to the drive key of a linear actuator. Bores with the designation “ G ” are equipped with sleeve bearings. With the screw locations z , the play of the guide bores d 1 / d 2 can be adjusted or the linear actuator connectors can be clamped after adjust- ment. Type B is equipped with seals at the screw locations. For quick clamping without tools, the cap nuts can be replaced by the adjustable levers GN 911.3 listed in the table as accessories. see also... • Stainless Steel Construction Tubes GN 990 → Page 1835 • Linear Actuators GN 291 → Page 1950 Information • Stainless steel AISI CF-8 Matte shot-blasted • Sleeve bearings Plastic (PTFE) • Carriage bolt DIN 603 Stainless steel • Cap nuts DIN 917 / washers Stainless steel • Seals - - Sealing disks Plastic (Polyacetal POM) - - Spacer ring Silicon, 40 ... 60 Shore A • Plastic Characteristics → Page 2158 • Stainless Steel Characteristics → Page 2166 • RoHS Specification • Adjustable Hand Levers GN 911.3 → Page 1785 Accessory 1 d 1 - d 2 b d 3 d 4 Mounting screws on the drive key k Clamping length l 1 m z Screw locations Accessory Recom. hand lever GN 911.3 for z l 2 One-Axis System GN 132.15 Two-Axis System GN 132.25 without sleeve bearing with sleeve bearing G30 - B30 G30 - G30 22 37 M 4 40 104 33 M  8 63 78 G50 - B50 G50 - G50 30 60 M 6 65 150 53 M 10 78 92 GN 132.15 GN 132.25 Linear Actuator Connectors for One-Axis System for Two-Axis System Stainless Steel 1 d 1 2 Type 3 Identification no. How to order (For two-axis system) 1 2 3 GN132.25-G50-G50-B-4 1 d 1 2 Type 3 Identification no. How to order (For one-axis system) 1 2 3 GN132.15-G30-B30-A-4