Standard_Parts_Catalogue

Page 1583 | 3.5 Controlling, Venting, Sealing of Liquids and Gases 3.1 3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 GN 848 Float Switch continued Electrical specifications Assembly instruction To change the type of contact (NO or NC), loosen the knurled screw and pull out the float rod. The switching magnet can now be placed in the recess on the opposite side, with the effect that the type of contact changes. Each housing carries a label which explains this mode of function. Max. switching voltage / Max. switched current: 230 V AC, 230 V DC / 2 A Max. switching capacity: 10 W Connector plug: DIN EN 175301-803 Type C Protection class: IP 65 Cable gland: PG 7, for cable-Ø from 6 to 7 mm Cable cross-section: 2 x 1,5 mm² Assembly sequence for cable connection 1. Loosen the mounting screw and pull off the connector plug. 2. Push the contact holder out off the connector casing. 3. Loosen the cable gland, feed the cable through the connector casing and connect to the contact holder. 4. Push the contact holder back into the connector casing and tighten the cable gland for strain relief grip / seal. 5. Push the connector plug over the connecting contacts of the float switch and secure with mounting screw.