Delay_System

20 Can I use the cylinder stroke partially, and possibly modify it, or must I always use 100% of the nominal stroke? Is it possible to block the rod return in any position? Is it possible to adjust the return speed of the rod? What speed can the system achieve? Is it possible to use cylinders of different sizes and strokes within a single installation? How does the contrasting force behave during the rod com- pression phase? What kind of pipes can I use for connecting cylinders inside the tool? How many cylinders can I connect to a single command unit? How are cylinders and command unit connected? Can I use the same command unit with different tools? How does the fluid which circulates inside the system cool down? Is it always necessary to cool down the circulating fluid? What maintenance does the system require? How do I make sure that the installation gets the input it needs for it to function? Can I use the Special Springs system with any type of Press? You can use any percentage of the nominal cylinder stroke and you can always adjust it according to your requirements and without any limits. Yes. Yes. Speed and rate vary from installation to installation. For further in- formation, contact Special Springs’ technical office. Yes. For further information, contact Special Springs’ technical office. Unless programmed differently, the force remains constant during the whole extent of the stroke. The size and type of pipes vary according to the installation and are usually decided at the dimensioning stage. For further information, contact Special Springs’ technical office. As a rule, there are no limits. For further information, contact Spe- cial Springs’ technical office. The connection is made by means of flexible hose pipes with quick coupling connectors onto the distribution unit attached to the tool. To connect cylinders and distribution unit, you may use flexible hose pipes or tubular plates suitable for oil flow. Yes, you can, provided the specifications of the command unit are suitable for such a use. For further information, contact Special Springs’ technical office. Thanks to the air-oil exchanger which is to be found on the com- mand unit. Yes. This takes place automatically thanks to a temperature sensor which switches the exchanger on. Oil change should occur every 5,000 working hours or every 2,5 years at the latest; always check the oil level before the start of a new production process; fill up if necessary. All cylinders are main- tenance-friendly. Just interface the command unit with the Press control unit. Yes. FAQ’S